Amana Tool Flush Trim 2-, 3-, 4-Flute Carbide-Tipped Router Bits With Ball Bearing Guide

Amana Tool Flush Trim 2-, 3-, 4-Flute Carbide-Tipped Router Bits With Ball Bearing Guide

Edge of Arlington offers free shipping in the United States when you choose flat rate shipping.

Use this flush trimming bit for laminate work or for template and pattern work. For template application, the bearing follows the template, while the cutting edges trim the workpiece. With the router handheld, the template is on the bottom of the work. With a table-mounted router, the template is on top.  Excellent for template work.

47090 & 47092: 1/4″ diameter for closer inside corner cutting only; bearings not guaranteed due to size.
47103 – single flute for the RV industry

A two-flute bit is a good general-purpose choice, providing fast cuts and good finishes; excellent for template work. For extremely smooth finish, choose the three-flute configuration; it’s especially good to use on laminates that tend to chip easily. For a super-smooth finish, use a four-flute bit; feed rate is reduced and chipping is virtually eliminated.

NOTE—See also:
MR0105, MR0102, MR0103 Miniature Bits
RC-2000 – Replacement knife #RCK-8 (2 required)
DRB-400 & DRB-404 – Polycrystalline Diamond (PCD) for extremely long life. Also good to cut composites & trim ACM materials & aluminum
RC-47104 – replacement knife #RCK-252 (2 required)

AMAX Extended Life Features:

200% longer life-time even when working with abrasive materials
Superior geometric design
Advanced grinding technology that improves the carbide’s resistance to wear
Super clean cuts

Sample, 2 Flute –