Amana Tool Solid Carbide Spiral Plunge with Corner Radius 1/16 Radius x 1/4 Dia x 3/4 x 1/4 Inch Shank Up-Cut ZrN Coated Router Bit

Thank you for shopping with us!

For carving, lettering, decorative doors and sign manufacturing.
Leaves an excellent finish and expels chips quickly.

Excellent for Cutting:


Aluminum

MDF

Soft/Hard Plastic

Soft/Hard Wood

Benefits of Zirconium Nitride (ZrN) Coatingbr>

Creates a harder and tougher cutting edge allows for a prolonged cutting edge life and helps to prevent the build up of material in the flutes while cutting

Have the tendency to run/spin much faster than an uncoated tool

Optimized flute geometry and low Total Indicated Runout (TIR) guarantees clean cuts, essentially eliminates sanding, and reduces chatter (where the machine or workpiece vibrates) under high chip loads (when used with low TIR spindles)

High flute volume supports high feed rates and chip loads

High aspect ratio for single pass deep-reach cutting

Flute geometry optimized for cutting sign foam, sign board, hardwoods, thermoplastics, and phenolic composites