Item # SPE25080T5, Everlast Astra Series 250mm Dia 80-Tooth 30mm Bore 2.2mm Plate 3.2mm Kerf Panel Saw (Metric Diameter MICRO-5 Tip)


Download as PDF
Edge of Arlington offers free shipping in the United States when you choose flat rate shipping

Ideal for table saw use to provide fine finishing cuts in plywood, veneered panels, single-sided laminated panels, masonite (coated or uncoated), along with crosscutting in hard or soft woods. Use blades with more teeth when sawing thinner materials to provide quality cut and finish. Triple chip grind is best used for cutting all types of abrasive materials such as chip board or dense laminates. All blades feature expansion slots with copper plugs to reduce noise, dissipate heat, and attenuate vibration during the cutting process.

Triple Chip Grind - TCG - This design uses a trapezoidal tooth with 45 deg bevel on each side, which performs the cutting work followed by a lower STR tooth (raker) tooth for clean-out. Strong tooth design for cutting harder materials such as manmade laminates (single-sided) and non-ferrous materials. Can be used for rip cutting and cross cutting.


MICRO-5 extra hard tips provide 3-5 times longer service than standard carbide. 
Diameter250 mm
Bore30 mm
Kerf0.125 in
Plate0.087 in