Item # 815-214, Mastercut 3 Flute Upcut High Helix Ripper
$325.40
Download as PDF
Edge of Arlington offers free shipping in the United States when you choose flat rate shipping
Material Finish-Top: Poor
Material Finish-Bottom: Excellent
Endmill Points are most often found on 3 and 4 flute routers. They’re good for achieving a smooth finish on a flat bottom surface, and are commonly used in the plastic routing industry.
Upcut routers are used when a good bottom finish is desired on the material. Chips flow in an upward direction.
| SPECIFICATIONS | |
| Diameter | 3/4 in |
|---|---|
| Cut Height, Length, or Width | 2 1/8 in |
| End Pt Type | Endmill |
| Flute Geometry | Upcut |
| Flute | 3 |
| Helix Angle | 30 deg |
| Overall Length | 5 in |
| Shank | 3/4 in |
| Manufacturer | Mastercut |